DTC P0564

BHE010200500W04

DTC P0564

Cruise control switch input circuit problem

DETECTION CONDITION

• The PCM monitors the input voltage from the cruise control switch when the engine is running. If the input voltage is less than 3.0 V for more than 2 min, the PCM determines that there is a cruise control switch input circuit problem.

Diagnostic support note

• This is a continuous monitor (Other).
• The MIL does not illuminate.
• PENDING CODE is available if the PCM detects the above malfunction condition.
• FREEZE FRAME DATA is available.
• The DTC is stored in the PCM memory.

POSSIBLE CAUSE

• Cruise control switch malfunction
• Connector or terminal malfunction
• Short to GND in wiring harness between cruise control switch terminal B and PCM terminal 5V
• PCM malfunction

Diagnostic procedure

STEP

INSPECTION

ACTION

1

VERIFY FREEZE FRAME DATA HAS BEEN RECORDED

• Has FREEZE FRAME DATA been recorded?
Yes
Go to the next step.
No
Record the FREEZE FRAME DATA on the repair order, then go to the next step.
2

VERIFY RELATED REPAIR INFORMATION AVAILABILITY

• Verify related service repair information availability.
• Is any related repair information available?
Yes
Perform repair or diagnosis according to the available repair information.
• If the vehicle is not repaired, go to the next step.
No
Go to the next step.
3

INSPECT CRUISE CONTROL SWITCH CONNECTOR FOR POOR CONNECTION

• Turn the ignition switch off.
• Disconnect the cruise control switch connector.
• Inspect for poor connection (such as damaged/pulled-out pins, corrosion).
• Is there any malfunction?
Yes
Repair or replace the terminal, then go to Step 7.
No
Go to the next step.
4

INSPECT CRUISE CONTROL SWITCH SIGNAL CIRCUIT FOR SHORT TO GND

• Turn the ignition switch off.
• Inspect for continuity between cruise control switch terminal B (wiring harness-side) and body GND.
• Is there any continuity?
Yes
Repair or replace the wiring harness for a possible short to GND, then go to Step 7.
No
Go to the next step.
5

INSPECT CRUISE CONTROL SWITCH

• Inspect the cruise control switch.
• Is there any malfunction?
Yes
Replace the cruise control switch, then go to Step 7.
No
Go to the next step.
6

INSPECT PCM CONNECTOR FOR POOR CONNECTION

• Turn the ignition switch off.
• Disconnect the PCM connector.
• Inspect for poor connection (such as damaged/pulled-out pins, corrosion).
• Is there any malfunction?
Yes
Repair or replace the terminal, then go to the next step.
No
Go to the next step.
7

VERIFY TROUBLESHOOTING OF DTC P0564 COMPLETED

• Make sure to reconnect all disconnected connectors.
• Clear the DTC from the PCM memory using the WDS or equivalent.
• Start the engine.
• Is the same DTC present?
Yes
Replace the PCM, then go to the next step.
No
Go to the next step.
8

VERIFY AFTER REPAIR PROCEDURE

• Perform the "AFTER REPAIR PROCEDURE".
• Are any DTCs present?
Yes
Go to the applicable DTC inspection.
(See DTC TABLE.)
No
DTC troubleshooting completed.