DTC P0410

BHE010200400W01

DTC P0410

AIR system problem

DETECTION CONDITION

• The PCM monitors the front HO2S output current when the AIR control is operating. If the output current is more than the specification, the PCM determines that there is an AIR system problem.

Diagnostic support note

• This is an intermittent monitor (AIR system).
• The MIL illuminates if the PCM detects the above malfunction condition in two consecutive drive cycles or in one drive cycle while the DTC for the same malfunction has been stored in the PCM.
• PENDING CODE is available if the PCM detects the above malfunction condition during the first drive cycle.
• FREEZE FRAME DATA is available.
• The DTC is stored in the PCM memory.

POSSIBLE CAUSE

• AIR system malfunction
• PCM malfunction

Diagnostic procedure

STEP

INSPECTION

ACTION

1

VERIFY FREEZE FRAME DATA HAS BEEN RECORDED

• Has FREEZE FRAME DATA been recorded?
Yes
Go to the next step.
No
Record the FREEZE FRAME DATA on the repair order, then go to the next step.
2

VERIFY RELATED REPAIR INFORMATION AVAILABILITY

• Verify related service repair information availability.
• Is any related repair information available?
Yes
Perform repair or diagnosis according to the available repair information.
• If the vehicle is not repaired, go to the next step.
No
Go to the next step.
3

VERIFY RELATED PENDING CODE OR STORED DTC

• Turn the ignition switch off, then to the ON position (Engine off).
• Verify the related PENDING CODE or stored DTCs.
• Are other DTCs present?
Yes
Go to the appropriate DTC inspection.
(See DTC TABLE.)
No
Go to the next step.
4

IDENTIFY TRIGGER DTC FOR FREEZE FRAME DATA

• Is DTC P0410 on FREEZE FRAME DATA?
Yes
Go to the next step.
No
Go to the FREEZE FRAME DATA DTC inspection.
(See DTC TABLE.)
5

INSPECT AIR SYSTEM OPERATION

• Perform the "AIR System Inspection".
• Is there any malfunction?
Yes
Repair or replace the malfunctioning part according to the inspection results.
Then go to the next step.
No
Go to the next step.
6

VERIFY TROUBLESHOOTING OF DTC P0410 COMPLETED

• Make sure to reconnect all disconnected connectors.
• Clear the DTC from the PCM memory using the WDS or equivalent.
• Soak the vehicle in a place that is at a temperature of approx. 25 °C {77 °F} for more than 6 hours.
• Start the engine.
• Verify the SAIR_EVAL PID to Yes.
– If not, soak the vehicle again.
• Is the PENDING CODE same as the DTC present?
Yes
Replace the PCM, then go to the next step.
No
Go to the next step.
7

VERIFY AFTER REPAIR PROCEDURE

• Perform the "AFTER REPAIR PROCEDURE".
• Are any DTCs present?
Yes
Go to the applicable DTC inspection.
(See DTC TABLE.)
No
DTC troubleshooting completed.